|
|
Once established, wildflowers enhance the
attractiveness of your landscape,
help control erosion, furnish food
and cover for wildlife, and provide maximum
enjoyment with minimal care. The plantings can be as small as a few square
This chapter explains how to establish wildflowers on your property and how to maintain them for long-term wildlife habitat and viewing pleasure. Key factors are careful site selection, preparation, and maintenance. This can include choosing plants that are suited to the soil, picking the right method and time of installation, controlling weeds before and after planting, and managing for long-term success. There is an important emphasis placed on planting native wildflowers. Native refers to those species that historically occurred naturally in an area (i.e. was not introduced). These native species are important to the Michigan ecosystem and its continued existence. Site ConsiderationIf the area you have selected is capable of growing a healthy lawn, it will most likely support the establishment of wildflowers. However, you must match the wildflowers you choose with the type of soil you have, the soil moisture, and the amount of light that the area receives. For wildflowers needing direct sunlight, the location should receive a minimum of eight hours per day. Also, be sure to pick a location for maximum viewing pleasure. In sites with less sunlight, such as wooded areas, you should look for plants that are tolerant of shade.
Soil moisture is equally important in deciding what wildflower species to plant. Moist soils have a generous amount of water in the subsoil throughout the growing season. Clues are periods of standing water in spring and fall. Dry soils include sandy and gravelly soils that drain readily and never have standing water, even after a heavy rain. Moderate or mesic soils include well-drained loams and clays. These soils may have standing water for short periods after a hard rain. To see which types of wildflowers grow best in which environments, refer to the tables that accompany the Wildflowers chapter in this section. Site PreparationIt is very important to remove all existing vegetation before planting wildflowers. If
this vegetation is not properly eliminated, you will have limited success with your
plantings.
Converting LawnsOne of the best ways to prepare a lawn for wildflower planting is to remove the top three inches of grass and soil, using a commercial sod cutter on big sites and a hand shovel on smaller sites. A second method is to apply herbicide in spring or fall when lawns are actively growing. In about two weeks or after the area has turned brown, cultivate once with a rototiller or disc, taking care not to disturb the soil deeper than two inches (to discourage deeper-soil weeds from sprouting). After one week cultivate again. If weeds continue to germinate after a week, you may need to spray again. Converting Old FieldsConverting an old field to wildflowers requires at least one full growing season to prepare the site. Burn or mow in early spring to remove the previous year's growth. Apply herbicide three times during the season: mid-spring, mid-summer, and early fall. This schedule allows you to attack different weeds which have peak growing activities at different times. Cultivate every two to three weeks to a depth of four or five inches. Be very consistent because it is important to rid the area of weeds before planting, especially grasses such as quack grass and reed canary grass. Converting Crop FieldsGood soils are more weed-prone than poor soils. For existing crop fields, spray with herbicide either after harvest in fall or after green up in spring. Similar to old fields, using cultivation and subsequent application of herbicide, work the soil all spring and summer. Once vegetation is fully removed, prepare the final seedbed by lightly tilling or discing, followed by dragging or raking. Caution: Do not plant wildflowers in fields treated with Atrazine within the last two years because wildflowers cannot tolerate this herbicide. A smother (or cover) crop of corn or sorghum will hold the soil from erosion for a year and control unwanted weeds until the Atrazine breaks down. On sites prone to erosion, do not leave the soil unvegetated for any length of time, and keep cultivation to a minimum. Plant the site as soon as it is ready or, if ready in the fall, plant a cover crop of oats at the rate of 100 pounds per acre or annual rye at the rate of one bushel per acre. When you are ready to plant the wildflowers in the spring, till the cover crop under. It is critical to use certified seed when planting cover crops so as to not introduce more weeds. SeedingOnce you have the site properly prepared, seeding can commence. If the soil is loose, roll or press with an ordinary lawn roller to firm it up. Sow the seeds with a whirlwind mechanical seeder or cast by hand. If you hand cast, consider mixing the tiny seeds with a slightly dampened inert material such as vermiculite, sawdust, or peat moss so the seed will stick to it. For a planting of 1,000 square feet, two-thirds of a bushel basket of inert material is plenty. For an area 1/10 acre in size (about 4,400 square feet) two bushel baskets will suffice. Mix the seed into the inert material. Evenly spread half of the total mixture over the area, then cast the other half while walking in a perpendicular manner to your first pass. If the seed has not already been mixed by your supplier, consider sowing each type of flower in small clumps or drifts throughout the area, which will mimic natural colonization. If planting in combination with native grass, sow the grass seed separately. Lightly rake and/or roll the site, taking care not to cover the seeds more than their average diameter (about 1/16th inch). Therefore, expect some seeds to be visible. Mulching may be necessary on potentially erosive slopes. If mulching, use only light material such as clean oat or wheat straw and cover no more than half of the bare soil. If necessary, water for four to six weeks, just enough to moisten the seeds with each application. Follow the supplier's instructions as to seeding rates. Wildflowers are generally planted at the rate of four to five pounds per acre although some seed supply companies recommend rates of six to eight pounds per acre. When seeding with native grasses, you may only need one pound wildflowers per acre, depending on the desired density of wildflowers. If using transplants, follow the supplier's planting instructions. Consider a large broadcaster or no-till grain drill for planting large areas. Because wildflower seeds are so small, adding a bag of cracked oats to the drill will help ensure even distribution of seeds, which will settle below the larger oats in the drill. Also, be sure to count the number of passes necessary to cover the field and then divide the seed into an equal number of passes. Fill the drill hopper after each pass with the correct amount of seed and oats. Post-plantingMost native wildflower seeds take at least three weeks to germinate. Do not expect to see blooms the first or possibly even the second year. Supplementing your planting with a few annual wildflowers will give you a show of color the first year. Many seed suppliers mix annuals with perennials for this reason. Be sure to check for aggressive exotic species in the mix to avoid problems. Expect a weed problem in the first year. Avoid the temptation to pull the weeds, because the wildflower seedlings may be dislodged. Instead, mow to a height of six to eight inches throughout the summer and into early fall (wildflowers do not usually grow taller than six inches the first year). This mowing will remove the seed heads of weeds before they are mature, which will prevent them from regenerating. If the planting was supplemented with annuals, however, mowing will sacrifice them unless you wait until the blooming period has passed. Consider spot mowing problem areas or over rough terrain with a stringed power weed trimmer. Mature establishment of perennial wildflowers will occur in three to five years. Weeds should not be a problem by then. Long-term ManagementIn the early spring of the second year, mow the planting to the ground and rake off the
cuttings. If weeds remain a problem in the second year, mow again in late spring or early
summer. To avoid damaging desirable plants, do not
Burning, which is also a valuable management tool for long-term success, can be started at the beginning of the third growing season. Burning removes the accumulated plant litter from the previous year's growth and exposes the soil surface to warming rays of the sun. It also encourages the growth, flowering, and seed production of native flowers and grasses. Conducting a burn right after snowmelt produces a slow, cool burn, which benefit wildflowers the most. A mid-spring burn, from three weeks after snowmelt to about 60 percent greenup, is most beneficial to prairie grasses because it helps set back undesirable cool season plants that begin their growth early in the season. Never initiate burning after new plant growth has reached one foot or taller, and be sure to check with local fire authorities for permits and other regulations. Plan to burn every three to five years. Splitting large parcels into thirds and burning or mowing one-third each year will help provide habitat diversity. If you have more than one planting area, burn or mow one planting per year. Wildflower
Planting Plan
|
|
feet of border around the vegetable garden or individual trees, or as large
as several acres. Even small areas of wildflowers, especially when coupled with grass,
tree, and shrub plantings, can shelter chipmunks, and migrating birds and can be used as a
travel 
Knowing your soil type is essential for successful establishment of
wildflowers. Information on soil types is available from county wide soil survey maps that
are available at your local 
There are many ways to eliminate existing vegetation, either
singly or in combination. Smothering the soil surface with plywood, a thick layer of
leaves, or a sheet of black plastic will kill many existing plants if the covering is left
in place for one full growing season. This practice is commonly used for areas less than
1,000 square feet. For more aggressive species, such as quack grass and Canada thistle,
you may have to leave the covering for a longer period of time. A low toxicity,
non-persistent 
mow after new plant growth has reached one foot or more. If you mow too late
in the fall, you may destroy the seedheads of coneflowers and coreopsis, which feed birds
in winter. Also, mowing too late in the season will remove vital nesting cover for early
spring, as well as remove the 
